MOVEMENT-SYSTEMS 2021.22

1 6 7 5 2 3 4 8 All dimensions in millimetres. Subject to changes. 461 INSTALLATION ADVICE Front holder with press-fit dowels Ø 10 x 12 mm Front holder with expansion dowels Ø 10 x 12 mm The front holes should be countersunk accordingly. With hard surface coatings such as melamine, the sharp edges of the holes can damage the dowels during press fitting. This can significantly reduce the pull- out resistance. This can significantly reduce the pull-out forces. Alternatively, front holders with expansion dowels can be used, which do not require countersinking and still guarantee optimum pull-out resistance. ADJUSTMENTS Cam height adjustment on both sides Loosen the locking screws on both sides. Adjust the front panel and tighten the locking screws again. Side adjustment on right Turn adjustment. Due to the integrated lateral adjustment, only the right-hand side needs to be operated. Front tilt angle adjustment The tilt angle of the front with a rectangular railing is adjusted using the front panel holder. The tilt angle of the front with a round railing is adjusted by turning the setting screw. Drawer systems.DWD XP. .Technical information. LEGEND BU Bottom edge FH Front height KB Cabinet width LWK Inside cabinet width Drawer systems DWD XP